Include specific details regarding which component(s) were replaced in the vehicle.1. 
Registered users can send a complete Auto-Scan via email. If the procedure results in an error message -or- does not complete as expected:. If you click the basic settings tests out of sequence, you may need to exit the module, cycle the key and repeat the entire process. SVM is a system used by VW/Audi to flash update control modules, and in certain cases, to change their Coding, Adaptation and configure Parameters.Įven if you have a complete Auto-Scan saved prior to replacing the Airbag module and the replacement part number is EXACTLY the same we strongly recommend using SVM to code and unlock CP for liability reasons.ĭue to liability concerns, Ross Tech does not offer assistance for installing used airbag components. The Coding and Parameterization steps are performed online as well, but those steps use a process called SVM (Software Version Management). Component Protection can only be learned/disabled using the Factory Tool in Combination with an online Connection with GeKo access. Replacement of the Airbag control module may result in Component Protection (CP) DTCs such as U1101 and U1100. Fault codes should clear after an ignition cycle. The seat occupied recognition reset reset has been performed. If a repair on the Seat Occupied Recognition has been performed, including the above procedure, a reset has to be performed too. Proceed directly to the Seat Occupied Recognition Control Module (J706): Reset Seat Occupied Recognition Control Module (J706): Reset The Seat occupied recognition serial number reset has been performed. Select the following from the pull-down menu: Passenger seat is empty and in normal position.Įnter the code shown in the pop-up balloon. If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the reset has to be performed. Special Procedures Seat Occupied Recognition Control Module (J706) Will appear in a pop-up balloon when connected to this controller with VCDS. 
See the Replacement section below.Ĭoding is performed using Software Version Management (SVM) with an online connection to Audi headquarters.Īdaptation is typically performed using Software Version Management (SVM) with an online connection to Audi headquarters when a brand new control module is installed. Replacement of Airbag10.43 control modules will result in Component Protection (CP) DTCs which cannot be resolved using VCDS. 5.2 Seat Occupied Recognition Control Module (J706): Reset.5.1 Seat Occupied Recognition Control Module (J706).
0 kommentar(er)
